cisco_apic¶
Warning
This is automatically generated. In case of any issues, please refer to the source code or, even better, open an issue on the GitHub repository. Thanks! 🤗📖
Commands¶
enable¶
Output: None
Help: enter enable mode
Prompt: - cisco_apic$
fabric show vlan extended¶
Output:
apic1# fabric 203 show vlan extended
----------------------------------------------------------------
Node 203 (lab1r00002-ne-RDC-LF3)
----------------------------------------------------------------
VLAN Name Encap Ports
---- -------------------------------- ---------------- ------------------------
9 5GC-N6:N3-INT:l3out-UPF-N3-INT- vxlan-15171532, Eth1/1, Eth1/2, Eth1/3,
VRF-FLT:vlan-541 vlan-541 Eth1/4, Eth1/5, Eth1/6,
Eth1/7, Eth1/8, Eth1/9,
Eth1/10, Eth1/11,
Eth1/12, Eth1/13,
Eth1/14, Eth1/15,
Eth1/16, Eth1/17,
Eth1/18, Eth1/19,
Eth1/20, Eth1/21,
Eth1/22, Eth1/23,
Eth1/24, Eth1/28,
Eth1/29, Eth1/30,
Eth1/31, Eth1/32,
Eth1/33, Eth1/34,
Eth1/35, Eth1/36,
Eth1/37, Eth1/38,
Eth1/39, Eth1/40,
Eth1/41, Eth1/42,
Eth1/43, Po1, Po2
11 NSO-XDOMAIN:Source-TG-BD vxlan-16318378 Eth1/16
12 NSO-XDOMAIN:Traffic- vlan-621 Eth1/16
Generators:source-tg-epg
14 infra:default vxlan-16777209, Eth1/1, Eth1/48
vlan-3914
Help: execute the command "fabric show vlan extended"
Prompt: - cisco_apic$ - cisco_apic#
default¶
Output:
% Invalid input detected
Help: default output for unknown commands
Prompt: - cisco_apic$ - cisco_apic#